Powerhead Assembly - Craftsman CMXEVBE176120 Instruction Manual

Wheels Assembly (Fig. E):
3. Position the Axle side of one of the Wheels into the
Drum, as shown. Push Wheel into the Tool Caddy
Hub. You will hear the Wheel snap into the Tool
Caddy. Repeat for the Second Wheel.
Fig. E
Wheel (2)
Axle
Powerhead Assembly (Fig. F)
1. Line up the Front (label and switch side) of the
Powerhead with the Vac Inlet Port located on the Front
of the Drum.
NOTE: Powerhead must be aligned with Drum for proper
attachment.
2. Place Powerhead on Top of Drum.
3. Be sure Powerhead completely covers the top of the
Drum so leakage does not occur.
4. Push down the Latches, and the Powerhead will attach
to the Drum.
5. To remove the Powerhead, pull up on the Latches and
remove from the Drum.
Tool
Caddy
Fig. F
Hub
On/Off
Switch
Powerhead
Drum Top
Handle
Latch (2)
Power
Cord
7