1 LINE AUDIO BRUTO KIT REF: 2235
Cod. 94545I
V07/05
AMPLIFIER
CALL PUSHBUTTON
Installation
Before embedding the box, break the flange
You could reinforce the subjection of the box
where the wires have to be passed through.
witch the screws of anchorage that are
included.
Push up the cover behind the nameplate and place
one label on it. You can use one of the labels supplied
with the outdoor panel.
Important notes:
The Outdoor Panel is protected against humidity and atmospheric agents since it has
a protection degree IP 559.
The Power Supply should be installed on a hard and flat surface (inside the building,
lobby, etc.) but always in inner places. It can be installed in a DIN box for electric switches.
Before installing the AUDIO BRUTO KIT, install the cables needed to Telephone (or
telephones), Outdoor Panel and Power Supply, following the installation diagram.
VOLUME CONTROL
LANGUAGE SELECTION
CONFIGURATION JUMPERS
PUSHBUTTON CONNECTIONS
1.7m
Place the waterproof tape supplied
in the KIT.
Close the panel and fasten the
screws with the Torx key supplied.
1 LINE AUDIO BRUTO KIT REF: 2235
Cod. 94545I
V07/05
AMPLIFIER
CALL PUSHBUTTON
Installation
Before embedding the box, break the flange
You could reinforce the subjection of the box
where the wires have to be passed through.
witch the screws of anchorage that are
included.
Push up the cover behind the nameplate and place
one label on it. You can use one of the labels supplied
with the outdoor panel.
Important notes:
The Outdoor Panel is protected against humidity and atmospheric agents since it has
a protection degree IP 559.
The Power Supply should be installed on a hard and flat surface (inside the building,
lobby, etc.) but always in inner places. It can be installed in a DIN box for electric switches.
Before installing the AUDIO BRUTO KIT, install the cables needed to Telephone (or
telephones), Outdoor Panel and Power Supply, following the installation diagram.
VOLUME CONTROL
LANGUAGE SELECTION
CONFIGURATION JUMPERS
PUSHBUTTON CONNECTIONS
1.7m
Place the waterproof tape supplied
in the KIT.
Close the panel and fasten the
screws with the Torx key supplied.