Related Manuals for ATECH SKAT-06 P
Summary of Contents for ATECH SKAT-06 P
- Page 1 SKAT – 06 P PEGASUS – 06 P 16” (400 mm) 14” (350 mm) MANUAL MITER SAW USER’S MANUAL...
-
Page 2: Table Of Contents
CONTENTS 1. GENERAL INFORMATION 1.1. Introduction 1.2. Information About The Distributor 2. MACHINE’S DESCRIPTION AND PURPOSE OF USE 2.1. Machine’s Description 2.2. Technical Features 2.3. Cutting Diagram 2.4. Dimensions 2.5. Electrical Diagram 3. SAFETY 3.1. Safety Information 3.2. Accident Prevention 3.3. -
Page 3: General Information
E-mail info@ATechMachinery.com *In case of any technical problem please contact your nearest ATECH dealer or ATECH head office through the above mentioned phone, fax or e-mail address. *Technical labels with the model description of the machine are fixed onto the front side of each machine. -
Page 4: Cutting Diagram
2.3. Cutting Diagram 2.4. Dimensions SKAT I ► PEGASUS I ►... -
Page 5: Electrical Diagram
2.5. Electrical Diagram 3. SAFETY 3.1. Safety Information The symbols shown hereunder are necessary to be read with special attention. Not reading or observing of them may cause damage to the equipment or personal injury. The IMPORTANT symbol above is one telling to apply special care and to be careful at carrying out the specified operation. The CAUTION! symbol above warns you against specific dangers and requires to read the text. -
Page 6: General Safety Information
3.2.4. Machine should be operated only by staff members, who have read and understood the contents of this manual. 3.2.5. All directives, recommendations and general safety rules contained in this manual have to be observed fully. The machine cannot be operated in any way for purposes other than those described herein. Otherwise, the manufacturer shall not be deemed responsible for any damages or injuries. -
Page 7: Transport Of The Machine
Read operating instructions Keep working environment clean, carefully before using or dry and tidy. maintaining the machine. 4. TRANSPORT OF THE MACHINE * The transport should be done by qualified personnel only. 4.1.1. The machine should be transported by lifting with proper equipment (not touching the ground during the transport). -
Page 8: Operation
7. OPERATION The miter saws PEGASUS / SKAT cut non-ferrous aluminum, PVC profiles and PVC materials. The operator adjusts (manually via knob) the cutting speed of the saw blade according to the material type to be cut. Inner and outer sharp edges of the carbide tipped circular saw blade ensures high quality clean cutting results. -
Page 9: Maintenance Service And Repair
Part Part Name Inbus M10x35 Washer 30x8x7 Saw Flange Saw Washer Coupling Rotor Shaft 9. MAINTENANCE SERVICE AND REPAIR 9.1. Periodic Checks And Starting To Work 9.1.1. Ensure that the table and all kind of parts are clean and dry. Degrease and dry the table. Especially ensure that the holding grips are clean and dry. -
Page 10: Components
11. COMPONENTS 11.1. Electrıc Components PART NAME ELECTRIC MOTOR MOTOR PATCHER POWER CABLE 4x1,5 mm 3,5 m ELECTRIC PLUG...
Need help?
Do you have a question about the SKAT-06 P and is the answer not in the manual?
Questions and answers