Table of Contents
Advertisement
www.commscope.com
8-32 nuts with lockwashers
(4 places)
Rear stabilizer
brackets
Step 2A – Route and Secure Cable to Shelf
Gland nut
(inside of shelf)
Cable entry
port
Cable
gland
Method B
Cable dressed
over shelf slide
Fiber management
bar
Method A
Cable looped to shelf slide
on opposite side of panel from
entry point into shelf
Note: This shelf is designed for direct connection of cables using cable glands inserted into cable entry ports as
shown above. Another method for securing cables is the use of optional rack mounted brackets. See instruction
sheet 860380781 for using rack mounted brackets.
8-32 screws
with lockwashers
(4 places)
2 Post Rack Mount
3603D-UDH-1U shelf
Store slack fiber in shelf
Cable ties or hook-and-loop strips
installed on outside of shelf slide
860479229
Issue 7, May 2013
Front
12-24
screws
(8 places)
Sliding shelf
fully extended
Cable tie or hook-and-loop
strip 3" (76mm) below shelf
Page 5 of 15
Advertisement
Table of Contents
