Table of Contents
Advertisement
www.commscope.com
Step 10 – Building Up and Stacking Trays
Top cover
3-tray stack
Note: Do NOT remove paper backing from adhesive on bottom of additional trays.
1. Align 4 holes on base (provided for plastic hardware) with 4 holes on elevated platforms of previous tray.
Additional trays must be rotated 180
2. Install snap rivet grommets and plungers.
3. Install top cover.
4. Repeat as required.
Note: Three trays may be used in a 1U shelf for a total of 144 fusion splices. Six trays may be used in a 2U shelf
for a total of 288 fusion splices and twelve trays may be used in a 4U shelf for a total of 576 fusion splices.
°
from the previous tray orientation.
860479229
Issue 7, May 2013
Snap rivet
plunger
Snap rivet
grommet
Page 15 of 15
Advertisement
Table of Contents
