400 Series Control Settings - Pentair Autotrol Performa 400 Series Service Manual

400 SErIES CoNtrol SEttINgS

440i Control (obsolete)
Skipper Pins
Day Arrow
Indicator Knob
Timer Locking Pin
Figure 5
Programming
1. Set days of regeneration on skipper wheel (Figure 5).
• Pull all skipper pins outward (away from control).
• Rotate skipper wheel until day arrow points to current
day or number 1.
• Depress skipper pin(s) at day(s) for which regeneration
is desired.
2. Set the time of day.
• Grasp timer knob and pull outward.
• Rotate in either direction until the timer arrow points to
the actual time of day.
• Release timer knob.
With the time of day properly set, the conditioner will
NotE:
regenerate at about 2:30 a.m. If you prefer to have
the unit regenerate at an earlier or later time, simply
set current time-of-day accordingly (e.g., to have the
unit regenerate at 4:30 a.m.—two hours later—set
the clock two hours earlier than the actual time
of day).
the timer locking Pin should always be horizontal
NotE:
(Figure 5) during operation.
Skipper Wheel
Time Arrow
Timer Knob
Autotrol
Performa Valve with 400 Series Control water Conditioning Control System
®
460i Control
Water Flow Indicator
PM Indicator
Time Set Button
Indicator Knob
Timer Locking Pin
Plug Receptacle
Figure 6
Programming
Plug the wall-mount transformer into a functioning electrical
outlet that is not controlled by a switch. Plug the transformer
into the transformer plug receptacle on the control.
Open the access door by pushing the raised tab on the door
toward the left while pulling the tab out (Figure 6).
time of Day Setting
With the jumper on the set of pins next to the word TIME
(Figure 7), set the time of day to the closest hour by pressing
the black TIME SET button. PM hours are indicated by a light
next to the letters PM on the display window.
the use of a small needle-nose pliers will aid in
NotE:
moving the jumper.
the unit is factory set to regenerate at 2:00 a.m. If
NotE:
you prefer to have the unit regenerate at an earlier
or later time, simply set the current time of day
accordingly (e.g., to have the unit regenerate at 4:00
a.m.—two hours later—set the clock two hours
earlier than the actual time of day).
the timer locking Pin should always be horizontal
NotE:
(Figure 6) during operation.
Hardness Setting
Move the jumper to the set of pins next to the word HARDNESS
(Figure 8). Press the black TIME SET button until the hardness
of the incoming water supply is displayed. The hardness range
is from 1 to 99 grains per gallon.
To change water hardness stated in parts per million (PPM) to
grains per gallon (GPG) use this formula:
Parts per Million = Grains per Gallon
17.1
Figure 7
Raised Tab
Hour Time Display
Access
Door
Jumper
Spare
Jumper
Transformer
Figure 8 Figure 9
• 5