Husqvarna 525LST Operator's Manual page 14

6. Attach the nut (G).
7. Tighten the nut to the support flange with the socket
wrench. Hold the shaft of the socket wrench near the
blade guard. Tighten in the opposite direction to how
the cutting attachment rotates. Tighten it to a torque
of 35-50 Nm.
Quick release function of the harness
WARNING: Do not use the harness if the
quick release function is defective. Make
sure that the quick release function operates
correctly when you adjust the product.
WARNING: If the product is not safely
attached to the harness, you can not control
the product and that can result in injury to
you or others.
The quick release function is at the front of the harness.
The harness straps must always stay at the correct
position.
In an emergency, the quick release function helps you to
remove the product safely.
To adjust the harness
WARNING: Always attach this product to the
harness correctly. If not, you cannot control
the product safely and this can result in
injury to you or others. Do not use a harness
with a defective quick release.
WARNING: Use the harness quick release
function if you must release from the product
and the harness in an emergency situation.
1. Put on the harness.
2. Adjust the harness for the best work position.
14
3. Adjust the side straps until the weight is equally
applied across your shoulders.
4. Adjust the harness until the cutting attachment is
parallel to the ground.
5. If the operation is to cut grass, let the cutting
attachment stay lightly on the ground. Adjust the
harness clamp to balance the product correctly.
Correct balance of the product
For forestry clearing, the product is correctly balanced
when it freely hangs horizontally from the suspension
point. With correct balance, the risk of hitting stones if
you release the handlebar is decreased.
1363 - 001 - 25.10.2019