Husqvarna 525LST Operator's Manual page 18

To start with a throttle handle with a
start throttle lock (525RS)
1. Push the throttle lockout and the throttle trigger to
set the throttle to the start position. Then push the
start throttle button (A).
2. Release the throttle lockout and the throttle trigger,
followed by the start throttle button. The throttle
function is now activated.
3. To return the engine to idle speed, push the throttle
lockout and throttle trigger again.
To stop the product
• Move the stop switch to the stop position to stop the
engine.
525RS
CAUTION: The stop switch automatically
goes back to start position. To prevent
accidental start, remove the spark plug
cap from the spark plug when you
assemble or do maintenance on the
product.
About the surface
WARNING: Do not touch the area that is
identified with gray in the illustration. There
is a risk of burn injuries when the product is
hot. There is a risk of electrical shock if the
spark plug cap is damaged. Do not use a
product that has a damaged spark plug cap.
18
A
525LST, 525RJD
Grass clearing with a grass blade
CAUTION: Do not use grass blades and
grass knives on wood. Use grass blades
and grass knives for long or heavy grass
only.
• Move the product from side to side.
• Start the movement from right to left when you cut.
Move the product to the right before you cut again.
• Cut with the left side of the grass blade.
• Angle the grass blade to the left to make the grass
fall in a line. This makes it easy to collect the grass.
• Keep a stable position with your feet apart.
• Move forward after each right movement and make
sure that you have a stable position again before you
cut again.
• Keep the support cup with a light pressure against
the ground to make sure that the grass blade does
not hit the ground.
• Obey these instructions to decrease the risk that cut
material winds around the grass blade:
a) Apply full throttle.
b) Do not move the grass blade through cut
material when you move the product from left to
right.
• Before you collect the cut material, stop the engine
and remove the product from the harness. Put the
product down on the ground.
1363 - 001 - 25.10.2019