Table of Contents
Advertisement
LMU Controller
Troubleshooting
This section provides information and procedures for troubleshooting the LMU Controller interface and the vMax Live Plus
software.
Troubleshooting
Symptom
LMU Controller will not start
LMU Controller is not detected by
vMax Live Plus
LMU Controller LEDs are on up to 15
minutes after ignition off.
p. 13
Possible Cause
The power cabling may not be
completely connected.
The GPS sensor cannot detect the
satellites.
The cellular connection is not
complete.
The LMU Controller is factory set to have a power off delay of 15 minutes to
allow for cellular transmission delays in communicating vehicle activity after the
vehicle reaches the yard and powers down.
© Safe Fleet | March 2019 | All rights reserved | Part #: 700-1132 R3
Troubleshooting
Solution
Check cabling connections.
Move the vehicle out of garage.
Check with Seon Technical Support.
Advertisement
Table of Contents
Need help?
Do you have a question about the LMU Controller and is the answer not in the manual?