Table of Contents
Advertisement
SAFETY PRECAUTIONS AND WARNINGS
- For safety reasons, the hob must only be used after being
installed. Consult this data before making the connection. In
case of uncertainty, contact an electrician.
- The connection data (voltage and frequency) indicated on
the data plate of the hob must fully correspond with that of
the electrical mains, otherwise the appliance could become
damaged.
- The appliance is not intended for operation with an external
programmer clock or with a remote control system.
- The hob must be connected to the electric mains by an
electrician. If a damaged power cord is replaced, a special
power cord must be installed by an electrician.
- To carry out installation, maintenance or repair work,
disconnect the hob from the power supply.
The appliance is only disconnected from the power supply if:
- the fuse of the electrical system is disabled or
- the fuses of the electrical system have been completely
unscrewed, or
- the plug (if present) has been removed from the socket.
To remove the plug, always hold it; never pull the cord.
- If the hob is equipped with a communication module,
make sure that the module is disconnected from the mains
during installation, maintenance or repair work.
- The filter of a module contains components that remain
charged after the main power supply has been removed.
In the event of residual voltage, the filter components must
discharge the voltage.
6
Advertisement
Table of Contents
