Husky H38CPRAT Use And Care Manual page 4

SERVICE
□ Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
□ Never service damaged BATTERY packs.
Service of BATTERY packs should only be
performed by the manufacturer or authorized
service providers.
SPECIFIC SAFETY RULES FOR
CORDLESS RATCHET
□ Know what is behind a workpiece before you
do the job. Do not cut into existing walls or other
blind areas where electrical wiring, water, or gas
pipes may exist. If this situation is unavoidable,
disconnect all fuses/circuit breakers, and shut off
any water and gas lines feeding this work site.
□ Hold the power tool by insulated gripping
surfaces, when performing an operation
where the fastener may contact hidden wiring
or its own cord. Fasteners contacting a "live"
wire may make exposed metal parts of the power
tool "live" and could give the operator an electric
shock.
□ Avoid overload working.
□ Do not touch bits, sockets, ratchet component
and workpiece immediately after use. They
may be very hot and could burn skin when
touching them after use.
□ Be prepared for a reaction torque when
"seating" or removing a fastener. The tool
housing may tend to twist in the opposite
direction of bit rotation when "seating" or
removing a fastener, depending on the torque
setting of the tool.
□ Do not use worn or damaged sockets and
accessories. Insert the socket well onto the
anvil. Be sure that the socket has locked onto the
anvil correctly.
□ Do not store or use the tool in locations where
the temperature may reach or exceed 140°F
(60°C), which can lead to deterioration of the
battery.
□ Do not incinerate the tool even if it is seriously
damaged or is completely worn out. This tool
contains Li-Ion batteries, the batteries can
explode in a .
IMPORTANT SAFETY RULES FOR
CHARGER
□ To reduce the risk of electric shock or damage
to the tool and charger, only use the charger
(model no. 7106) provided by the
manufacturer.
□ Do not charge the tool if case is cracked or
damaged. Electric shock and
injury.
□ Do not expose charger to rain or snow.
□ This charger is not intended for any uses other
than charging the ratchet. Any other use may
result in risk of re, electric shock or
electrocution.
□ Do not disassemble charger. Take it to a
service person when service or repair is
required. Incorrect reassembly may result in a
risk of electric shock or
□ To prevent the risk of electric shock, unplug
the charger from the outlet before attempting
to clean it.
□ Do not use the charger in locations where the air
temperature is below 32°F (0°C) or above
(40°C) . This is important and will prevent
to the battery and charger.
WARNING: To reduce the risk of injury,
user must read and understand instruction
manual.
WARNING: This manual contains
important safety and operating instructions
for your charger. Before using the charger,
read all instructions and warnings on the
charger and the tool.
WARNING: Always wear proper personal
hearing protection that conforms to ANSI
S12.6 (S3.19) during use.
4
can cause
.
104°F