Safety; Symbols Used; Warnings; Notes On Ce Marking - MICRO-EPSILON IF2008 ETH Operating Instructions Manual

Safety

NOTICE
IF2008 ETH
1. Safety
System operation assumes knowledge of the operating instructions.
1.1

Symbols Used

The following symbols are used in these operating instructions.
Indicates a hazardous situation which, if not avoided, may result in
minor or moderate injury.
Indicates a situation that may result in property damage if not
NOTICE
avoided.
Indicates a user action.
i
Indicates a tip for users.
Measurement
Indicates hardware or a software button/menu.
1.1

Warnings

Connect the power supply and the display / output device according to the safety regula-
tions for electrical equipment.
> Risk of injury
> Damage to or destruction of the interface module.
The supply voltage must not exceed the specified limits.
> Risk of injury
> Damage to or destruction of the interface module.
Avoid shocks and impacts to the interface module.
> Damage to or destruction of the interface module.
1.2

Notes on CE Marking

The following apply to the IF2008 ETH interface module:
- EU Directive 2014/30/EU
- EU Directive 2011/65/EU, "RoHS" Category 11
Products which carry the CE mark satisfy the requirements of the EU directives cited and
the European harmonized standards (EN) listed therein. The EU Declaration of Conformi-
ty is available to the responsible authorities according to EU Directive, article 10, at:
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Koenigbacher Str. 15
94496 Ortenburg / Germany
The measurement system is designed for use in industrial environments and meets the
requirements.
1.2

Intended Use

- The IF2008 ETH interface module is designed for use in industrial and laboratory ap-
plications. It is used to convert the MICRO-EPSILON internal sensor protocol (RS422)
to Ethernet.
- The IF2008 ETH interface module must only be operated within the limits specified in
the technical data, see 2.
- The IF2008 ETH interface module must be used in such a way that no persons are
endangered or machines and other material goods are damaged in the event of mal-
function or total failure of the controller.
- Take additional precautions for safety and damage prevention in case of safety-related
applications.
Page 5