Classe Audio Delta MONO Owner's Manual page 8

8
Caution! If you see the Standby LED indicator blinking red, please
check that all external connections are cleanly made
and secure. If no fault is immediately obvious, try to
reset the amplifier by pressing and holding the standby
button. If the unit does not reset or continues to enter
protection mode, please call your authorized Classé
dealer for assistance.
2 ICTunnel
The Intelligent Cooling Tunnel removes heat from the amplifier by pulling
cool air through the intake on the front panel. To ensure the proper
operation of the cooling system, be careful to keep the area around the air
intake on the front panel free of obstructions.
3 Output VU Meter
The output meter shows output power in Watts into an 8 ohm load and
provides a good relative indication of output in dB. A good rule of thumb
is that when the pointer is below/left of vertical the amplifier is operating
in class A.
The backlight of the VU meter may be adjusted to three different
brightness levels or turned off. To adjust the brightness level, with the
amplifier in standby, press and hold the standby button for approximately
5 seconds. The backlight will begin cycling through its brightness levels.
When the desired brightness is reached, release the button.
Air Intake
™