Basic Operation; Power On; Adjust The Volume; Select A Zone - Kenwood ProTalk DIGITAL NX-P1200NV User Manual

POWER ON

Turn the Power switch/ Volume control clockwise to switch the
transceiver power ON.
• Power-on tone will sound.

ADJUST THE VOLUME

Rotate the Power switch/ Volume control to adjust the volume.
• Clockwise increases the volume and counterclockwise decreases the volume.
Note:
◆ To adjust the volume using background noise as a reference in Analog mode, use the
[Monitor] or [Squelch Off] function.

SELECT A ZONE

Press and hold the Side 1 button for 1 second to increase the
Zone number (Zone 1Zone 2Zone 3Zone 4Zone 1).
Press and hold the Side 2 button for 1 second to decrease the
Zone number (Zone 4Zone 3Zone 2Zone 1Zone 4).
• Side 1 and Side 2 buttons are the default settings.

SELECT A CHANNEL

Rotate the Selector to select your desired channel.

MAKE A CALL

Press and hold the PTT switch, then speak into the microphone
using your normal speaking voice.
• Hold the microphone approximately 3 to 4 cm (1.5 inches)
from your mouth.
Release the PTT switch to receive.
Note:
◆ When the battery pack voltage becomes too low, transmission will stop and an alert
tone will sound.

BASIC OPERATION

9