Tx Setup - Kenwood ProTalk DIGITAL NX-P1200NV User Manual

TX Setup

When Channel Type is "Mixed" (Dual), set to "Analog" or "NXDN" (Digital) for
Transmit Mode.
To set the Transmit Mode
During CHANNEL SETUP, rotate the Selector to select a channel number.
1
• The transceiver announces the zone number and channel number.
Press the Side 1 or Side 2 button to select the TX Setup Mode.
2
• The transceiver announces "TX Mode".
• If the Frequency of the currently selected channel is set to "Off", the TX
Setup Mode cannot be selected.
• If the Channel Type is set to "Analog" or "NXDN" (Digital), the TX Setup
Mode cannot be selected.
Press the PTT switch to enter the Transmit Mode Selection.
3
Press the Side 1 or Side 2 button to select the Transmit Mode.
4
Transmit Mode
Analog
NXDN
Press the PTT switch to temporary save the selected Transmit Mode.
5
• Beep B (2 beeps) will sound.
• Repeat steps 1 to 5 to set up another channel.
Press the Side 1 or Side 2 button to select the Confirmation Setup Mode.
6
• The transceiver announces "Confirm".
Press the PTT switch to save the settings and return to the ID SETUP/ ZONE
7
SELECTION.
• Beep B (2 beeps) will sound.
• Turn the transceiver power OFF and then ON return to normal operation
with new settings.
Note:
◆ If no action is performed for 20 seconds, the transceiver will automatically return to
normal operation without changing any settings.
Voice Announcement
TX Mode Analog
TX Mode Digital
Transmitting in Analog.
Transmitting in Digital.
27
Description