Disassembly; Assembly; Using Your Ice Cream Maker - Wolfgang Puck SWPTEIC300 Use And Care Manual

Disassembly

•
Remove the assembled Motor
Housing from the Freezer Chamber
by rotating the Motor Housing a
quarter turn counterclockwise and
lifting straight up (see Figure 1).
•
Grasp the Mixing Bowl by the
Handle and lift straight out of the
Freezer Chamber.
•
Remove the Mixing Paddle by
pulling it straight out of the Shaft of
the Motor Housing.
•
Remove the Motor Housing from
the Transparent Lid by turning
the Nut located on the Shaft
counterclockwise to remove (see
Figure 2). Pull the Motor Housing
straight out from the Transparent
Lid.

Assembly

•
Place the Motor Housing in the
Transparent Lid until it is flush with
the bottom. Place the Nut over the
Shaft and turn clockwise until hand
tightened.
•
Insert the Shaft of the Motor
Housing into the top of the Mixing
Paddle until it snaps into place.
•
Insert the Mixing Bowl into the
Freezer Chamber by aligning the
ends of the Handle of the Mixing
Bowl with the receptacles of the
Freezer Chamber (See Figure 3).
•
Place the assembled Motor Housing
into the Freezer Chamber with the
Motor Housing slightly to the right
of the Control Panel (see Figure 1).
Turn the Motor Housing clockwise
until it is directly facing the Control
Panel (see Figure 4).
Figure 1
Figure 2
Figure 3
Figure 4
8

Using Your Ice Cream Maker

•
Please read the Helpful Hints section on the next page of this manual
before making your ice cream.
•
Place the Ice Cream Maker on a stable and flat surface and allow room
for proper air ventilation around the ventilation grates on an all sides of
the Appliance Housing.
•
Attach the Power Cord to the front Cord Receptacle of the Appliance
Housing first, then plug into wall outlet. When plugged in, the appliance
will be in standby mode and the red Standby/On indicator light will
illuminate.
•
Prepare your ice cream recipe and pour the mixture into the removable
Mixing Bowl. Never pour ingredients directly into the Freezer Chamber.
Do not add items such as seeds, peels, or pits into the recipe. See Helpful
Hints section to understand when to add extra ingredients.
•
Place the assembled Motor Housing into the Freezer Chamber with the
Motor Housing slightly to the right of the Control Panel (see Figure 1).
Turn the Motor Housing clockwise until it is directly facing the Control
Panel (see Figure 4).
•
Press either the "Hard" or "Soft" button to begin operation. "Hard" will
provide a slightly firmer texture than the "Soft" setting. The Mixing
Paddle will begin rotating.
•
Depending on the quantity and type of ingredients used as well as the
room temperature, the unit will take between 45-120 minutes to make
ice cream.
•
The Ice Cream Maker will beep once the ice cream is ready. Your can
stop the Mixing Paddle anytime once the ice cream has reached your
desired consistency by pressing the Standby/On button.
•
Remove the assembled Motor Housing from the Freezer Chamber by
rotating the Motor Housing a quarter turn counterclockwise and lifting
straight up (see Figure 1). Depending on consistency of ice cream the
Mixing Paddle could still be in the Mixing Bowl. Simply remove and set
aside.
•
Lift the Mixing Bowl by the Handle out of the Freezer Chamber and use
a scoop or the included Spatula to remove the ice cream. Transfer to a
freezer-safe container or serve immediately.
9