EVAPCO LPT Series Rigging And Installation Manual page 12

Low Profile Forced Draft Towers, Coolers and Condensers
Accessory Location Checklist
Accessories can ship in a variety of locations depending on the type of accessory, the size of the unit and the accessories
purchased with the unit. See Table 7 for a guide to accessory location.
Unit Accessories
Aluminum Ladder
Discharge Attenuation
Discharge Hood with Dampers
Electric Basin Heater
Electric Basin Heater Low Water Cutout Shipped in Rigging Box Strapped Inside Unit Basin
Electric Basin Heater Thermostat
Electronic Water Level Control Probes
Electronic Water Level Control
Factory Mounted Crossover Piping
Fan Screens (If not mounted)
Hot Water or Steam Coil
Inlet Attenuation
Remote Sump Trash Screen
Rigging Hardware
Safety Cage
Sealer Tape
Sump Sweeper Piping with and without
High Flow Eductors
Vibration Switch
Water Silencers
EVAPCO Europe
Phone: (32) 12 395029 • Fax: (32) 12 238527 • E-mail: evapco.europe@ evapco.be
EVAPCO Europe Srl • Via Ciro Menotti 10 • I-20017 Passirana di Rho, Milano, Italy
Phone: (39) 02 9399041 • Fax: (39) 02 93500840 • Email: evapcoeurope@evapco.it
EVAPCO Europe GmbH • Meerbuscher Str. 64-78, Haus 5 • D-40670 Meerbusch, Germany
©2013 EVAPCO Europe
Bulletin 123-E Metric 0519
Table 7 – Unit Accessory Shipping Location
Shipping Location
Shipped Separately on Truck Bed
Shipping Location is Unit Dependent
- If Space is Available: Loosely Mounted on Unit
- If No Space is Available: Shipped Separately on Truck Bed
Shipping Location is Unit Dependent
- If Space is Available: Loosely Mounted on Unit
- If No Space is Available: Shipped Separately on Truck Bed
Shipping Location is Unit Dependent
- End Mounted Heater: Installed in Unit Basin
- Side Mounted Heater: Strapped Inside Unit Basin
Shipping Location is Unit Dependent
- End Mounted Thermostat: Mounted on Unit Basin
- Side Mounted Thermostat: Shipped in Rigging Box
Mounted in PVC standpipe
PVC Standpipe Strapped Inside Unit Basin
Welded to Coil Connections
Shipping Location is Unit and Accessory Dependent
- If Space is Available: Strapped Inside Unit Basin
- If No Space is Available: Crated and Shipped Separately on Truck Bed
Installed in Unit Basin
Shipping Location is Unit Dependent
- If Space is Available: Loosely Mounted on Unit
- If No Space is Available: Shipped Separately on Truck Bed
Installed In Unit Basin
Shipped in Rigging Box Strapped Inside Unit Basin
Attached to the Ladder
Shipped in Rigging Box Strapped Inside Unit Basin
Installed in Unit Basin
Mounted in Fan Section
Installed in Unit Basin
• Industriezone, Tongeren-Oost 4010 • 3700 Tongeren, Belgium
bvba
Phone: (49) 2159-6956-0 • Fax: (49) 2159-6956-11 • Email: info@evapco.de