Advertisement
Available languages
Available languages
Screw Type
1
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber
washer within the hose makes contact to the tap.
Do not install the hose if the black washer is missing.
2
Connect the water supply hose to tap.
Connect the water supply hose to the tap and then
tighten it by screwing it to the right.
Do not over tighten, or use any mechanical tools to
tighten . Hand tighten only. A soft cloth can be used
to assist the hand tightening.
3
Check for water leakage.
After connecting the hose at both ends open the
tap to check for any water leakage.
Connecting Water Supply Hose to the machine
• Connect the water supply hose to inlet valve of the
washing machine, and then tighten it by turning the
hose connecting part.
• Check to ensure that the rubber washer is inside the
connector.
Caution
• Do not store or install the washer outdoors, or where it is directly exposed to sunlight, wind, etc.
• Permissible water temperature : Max 60°C.
• Permissible water pressure : Max 800 kPa , Min 30 kPa
• If water temperature & pressure is greater than above, it may cause damage to the machine or a
malfunction. If you have uncontrolled water temperature & pressure you should fit a temperature
& pressure relief valve to ensure that water temperature & water Pressure remains within the
safe limits. Consult a plumber or electrician if you are unable to adjust water temperature and
pressure.
• Do not over tighten the inlet hoses with a tool. The Inlet valves have a plastic thread. : Do not
strip or crossthread.
Water tap
Hose connector
29
Rubber Packing
Water Supply Hose
Rubber Washer
Advertisement
