Table of Contents
Advertisement
Super AOC-S100G-b2C Add-On Card User's Guide
2-4
NC-SI Header & PCI-E 4.0 x16 Connector
NC-SI Header
A Network-Controller Sideband Interface (NC-SI) header is located at JNCSI1 on
the add-on card. Connect an appropriate cable from this header to a motherboard
to provide an out-of-band (sideband) connection between the onboard Baseboard
Management Controller (BMC) and a Network Interface Controller (NIC) for remote
management. For the network sideband interface to work properly, you will need
to use a motherboard that supports NC-SI and also need to have a special cable.
Please contact Supermicro at
header. See the layout below for the location of the JNCSI1 header.
PCI-E 4.0 x16 Connector
A PCI-E 4.0 x16 connector is located at JGF1 on the add-on card. Insert this con-
nector into a PCI-E 4.0 x16 slot on a motherboard to use this add-on card. See the
layout below for the location.
QSFP28
QSFP28
www.supermicro.com
AOC-S100G-b2C
REV:1.01
DESIGNED IN USA
BCM57508
2
2-4
to purchase the cable for this
1. NS-CI Header
2. PCI-E 4.0 x16 Connector
1
Advertisement
Table of Contents
