Fitting The Cabinet Doors - Miele KFN 37232 iD Operating And Installation Instructions

Installation
To give the appliance additional se-
curity in the niche, push the rods sup-
plied between the appliance and the
cabinet base:
 First secure the handle  to one of
the stabilizing rods .
 Use the handle to push the stabilizing
rod  into the guide as far as it will
go. Remove the handle  and fit it to
the other stabilizing rod supplied and
push this into its guide as far as it will
go.
Tip: Keep the handle somewhere safe
in case you ever need to fit the appli-
ance into a new housing unit.
 Close the appliance doors.
72

Fitting the cabinet doors

The cabinet door must be min.
5/8" (16 mm) or max. 3/4" (19 mm)
thick.
The following gap dimensions must be
maintained:
– The gap between the cabinet door
and the cupboard door above it must
be min. 1/8" (3 mm).
– The vertical gap between the cabinet
doors should be approx. 3 mm. The
exact value will depend on the radius
of the edge of the cabinet door.
If fitted in a run of units make sure that
the top edge of the cabinet door is at
the same height as neighboring unit
doors.
The appliance door must be under no
stress or burden while being fitted.