Special Functions - Ariston DEOS 21s User Manual

GB
6. TURBO/SELF CLEAN BUTTON
TURBO
Press to select the fan speed: normal (the " " indicator light turns on) or turbo (the " " indicator light turns on).
NOTE: the TURBO button is disabled in SUPER LAUNDRY ROOM mode and when the SELF CLEAN, AIR PURIFIER and ANTI-MOULD special functions
are enabled.
SELF CLEAN
Pressing the TURBO button for more than 3 seconds enables the SELF CLEAN function.
7. PURE/ANTI-MOULD BUTTON
PURE
Press this button to select the AIR PURIFIER function which uses the included HEPA (High Efficiency Particulate Air) filter
to reduce the dust, bacteria and allergen content in the room.
ANTI-MOULD
Pressing the PURE button for more than 3 seconds enables the ANTI-MOULD function.
CAUTION
Do not touch the selector with wet hands (risk of personal injury due to electrocution).
Do not start or stop the appliance by simply plugging it into the power socket or unplugging it (risk of personal injury due to
electrocution).
Avoid prolonged direct exposure to the air flow (risk of personal injury due to sensitisation of the skin).
AUTO-RESTART
This function enables the dehumidifier to restart, after a power failure, from the last stored settings.
ANTI-FROST FUNCTION
Prevents the evaporator from frosting, thereby extending the dehumidifier's life and enhancing energy saving. When this
function is active, the fan continues to run while the compressor stops and 'P1' appears on the display.
TANK FULL STOPPAGE
The dehumidifier stops when the condensate collection tank is full or incorrectly positioned. 'P2' displays together with in-
dicator light .
NOTE: when the compressor stops, it is necessary to wait 3 minutes before it restarts.
ANTI-MOULD FUNCTION
Hold the PURE button down for more than 3 seconds to enable this function. It sets the fan speed and hours of operation of
the dehumidifier (up to 4h) in relation to the measured actual humidity. This maximises occupant comfort while reducing the
risk of mould and bacterial growth.
To disable the function, hold the PURE button down for more than 3 seconds or select an operating mode with the MODE
button.
SELF CLEAN
Hold the TURBO button down for more than 3 seconds to enable this function; the displays reads SC for 5 seconds and then
clears.
The SELF CLEAN function initiates as soon as the dehumidifier is switched off, and runs for 15 minutes; the display reads SC
while the function is active.
The function cleans and dries the heat exchangers with ventilation/dehumidification cycles, thus keeping them in perfect
working order.
To deactivate SELF CLEAN, hold down the TURBO button for 3 seconds; SC flashes on the display for 5 seconds and then
clears.
AIR PURIFIER FUNCTION
This function significantly reduces the dust, bacterial and allergen
content of the room, using the HEPA (High Efficiency Particulate Air)
filter supplied with the dehumidifier.
Press the PURE button to activate the AIR PURIFIER function; all other
modes and special functions are inhibited while it is running. Make
sure you have fitted the HEPA filter as indicated in fig.A .
CAUTION
Incorrectly installing the filter or forcing it into place can cause the
dehumidifier to malfunction, overheat and even fail.
18 /

SPECIAL FUNCTIONS

Fig.A