Control Panel - Ariston DEOS 21s User Manual

PURE
7
1. POWER BUTTON
Press to switch the dehumidifier on and off.
2. MODE BUTTON
Press to select the desired operating mode: STANDARD, SUPER LAUNDRY ROOM, CONTINUOUS or AUTO.
, STANDARD mode - the dehumidifier runs until it reaches its humidity setting.
SET
, SUPER LAUNDRY ROOM mode, the dehumidifier automatically sets the fan speed and relative humidity in relation
to the ambient temperature. The mode remains active up to 10h.
NOTE: in this mode you cannot change the fan speed or relative humidity settings.
, CONTINUOUS mode, the dehumidifier runs at maximum power without time limit.
, AUTO mode, the dehumidifier sets the relative humidity in relation to the ambient temperature to maximise occupant
comfort, according to the following rules:
NOTE: in this mode you cannot change the relative humidity setting.
3. HUMIDITY SETTING/TEMPERATURE DISPLAY
HUMIDITY SETTING
The relative humidity level can be set from 35% (minimum) and 80% (maximum), with 5% increments each time the '+' and
'-' control buttons are pressed. When the set humidity level is reached, the compressor stops and the fan continues to
run for 3 minutes.
NOTE: the humidity setting buttons are disabled in SUPER LAUNDRY ROOM, CONTINUOUS and AUTO modes.
TEMPERATURE DISPLAY
You can display the ambient temperature (°C) by holding down the "+" button for more than 3 seconds. You can do this
whether the dehumidifier is running or not, so long as it is connected to its power supply. The ambient temperature dis-
plays for 10 seconds.
4. LCD DISPLAY
The display shows the operating mode, actual and set relative humidity, ambient temperature, fan speed, timer, special
functions and shutdown alarms.
When the dehumidifier is connected to its power supply, the actual relative humidity displays; to display the ambient
temperature, hold down the "+" button for more than 3 seconds.
5. TIMER BUTTON
Pressing this button programs a delay after which the dehumidifier will start or stop. When set, the TIMER ON / TIMER
OFF icon displays. Press or hold the "+" and "-" control buttons to set the delay: in 0.5 h (30 min) increments for 0-10
hours, and 1h (60 min) increments for 10-24 hours.
Set the delay to 0.0h to cancel the TIMER ON / TIMER OFF function.
NOTE: You can set the TIMER whether the dehumidifier is running or not, so long as it is connected to its power supply.

CONTROL PANEL

TURBO TIMER
6 5
Detected room temperature
T ≤ 18 °C
18 °C < T < 25 °C
T ≥ 25 °C
°C
SET
A
ON OFF
4 3
Set relative humidity
55%
50%
45%
MODE POWER
2 1
/ 17
GB