Adjusting The Set Point - Samson 4708-45 Mounting And Operating Instructions

5.2 Adjusting the set point

Î See Fig. 1 on page 9.
Î Unscrew the cap on the set point screw
and adjust the set point of the supply
pressure regulator.
Î Turning the screw clockwise increases the
output pressure and turning it counter-
clockwise reduces the output pressure.
Î Lock the setting with the lock nut.
NOTICE
!
Risk of damage to the supply pressure regu-
lator due to excessively high tightening
torque applied to the lock nut.
Do not exceed the maximum torque of
7 Nm.
EB 8546-1 EN
Mounting the supply pressure regulator
17