Advertisement
vacon • 2
1.1.2
Installation
• Remove the cover from the drive. See the Figure 2.
1
• Open only the inlet holes where you need to run the cables. Cables pass
2
• Connect the supply cable to the Mains switch passing through the cable gland
3
• Place the Simple Operator panel assembly with the cables inside the drive and
4
• Connect the cables from the Mains switch to the line terminals. The cables
5
• Fix the cables with the cable clamp.
6
1
Figure 2. Cover open.
through this inlet hole.
from the bottom side (use the cable gland for sealing the cable to the drive)
and then through the terminal box as shown in the figure below.
fix it with its screws.
have to be connected to the terminals L1, L2 and L3.
Vacon 20 X - Simple operator panel
Advertisement
