Security Management; Http Authentication - HIKVISION iDS-7200AHQHI-M Series User Manual

Restore Defaults
Restore all parameters, except the network (including IP address, subnet mask, gateway,
MTU, NIC working mode, default route, server port, etc.) and user account parameters, to
the factory default settings.
Factory Defaults
Restore all parameters to the factory default settings.
Restore to Inactive
Restore the recorder to inactive status.
Note
The recorder will reboot automatically after restoring to the default settings.

11.9 Security Management

Enter a short description of your concept here (optional).
This is the start of your concept.

11.9.1 HTTP Authentication

If you need to enable the HTTP service, you can set HTTP authentication to enhance access
security.
Steps
1. Go to System → System Service → System Service .
2. Check Enable HTTP.
3. Select HTTP Authentication Type.
Note
Two authentication types are selectable, for security reasons, it is recommended to select
digest as the authentication type.
4. Click Apply to save the settings.
5. Restart the device to take effect the settings.
ATM Digital Video Recorder User Manual
Figure 11-13 HTTP Authentication
95