Advertisement
■ When laying cables after drilling a hole through the wall
Step 1
Decide the mounting position, and drill a hole for a screw or
an anchor and a hole for cable installation in the wall.
Procure 4 pieces of M10 screws and anchors to secure the
this bracket on the wall.
All screws and anchors shall be stainless steel. The hole
diameter shall be decided in accordance with the screws
and anchors to be used.
A hole on the wall with a diameter of 30 mm {ø 1-3/16
inches} or less for a screw or an anchor can be hidden with
this bracket.
80 mm
{3-5/32 inches}
8
Step 2
Mount the cable cap (accessory) on the cable access hole
(front).
Step 3
Make a slit in the center of another cable cap (accessory)
with a cutter.
Step 4
Remove the 4 screws from the rear side of the bracket,
remove the plate, and mount the cable cap that was slit in
Step 3.
Hole for cable
installation: ø30 mm
{ø1-3/16 inches}
Plate
The slit
Cable access
cable cap
hole (rear)
Advertisement
