Advertisement
Step 5
Thread the cables in the cable access holes in the wall
through the slit cable cap and mount bracket (WV-Q185)
successively.
For the cable length that needs pulling out in advance,
please refer to the operating instruction of WV-Q186 or
WV-Q187.
Secure the plate with the 4 screws removed in Step 4 on
the rear side of the bracket, and seal the slit of the cable
cap.
(Recommended tightening torque: 0.78 N·m {0.58 lbf·ft})
Q185
Outside
Cable
Inside
The slit cable cap
Sealant (locally procured)
Cable cap (with a slit)
Step 6
After waterproofing the hole for fixing mount bracket, the
port for pulling out the cable on installation surface, and the
cap part on rear surface of mount bracket, fix the mount
bracket on the installation surface.
Mount this bracket on the wall with 4 screws (M10: locally
procured).
Minimum pull-out strength: 823 N {185 lbf}/per 1 pc.
Step 7
For the installation method of WV-Q186 or WV-Q187 as well
as the connection and storage of the cables, please refer to
the operating instruction of WV-Q186 or WV-Q187.
9
Advertisement
