Advertisement
Installations/Connections
Be sure to read "Precautions" and "Precautions for installation" before installation.
Read the operating instructions for WV-Q186 or WV-Q187 to be installed as well.
The installation of the wall mount bracket is roughly divided into 2 methods.
Refer to the applicable description.
■ When laying cables through the cable access hole (front) (
■ When laying cables after drilling a hole through the wall (
■ When laying cables through the cable access hole (front)
Step 1
Decide the mounting position and drill a hole in the wall.
Procure 4 pieces of M10 screws or anchors to secure the
this bracket on the wall.
All screws and anchors shall be stainless steel. The hole
diameter shall be decided in accordance with the screws or
anchors to be used.
{3-5/32 inches}
6
80 mm
☞
6 page)
☞
8 page)
Step 2
Make a slit in the center of the cable cap (accessory) with a
cutter.
Step 3
Thread the cable through the slit cable cap and wall mount
bracket (WV-Q185) successively.
For the cable length that needs pulling out in advance,
please refer to the operating instructions of WV-Q186 or
WV-Q187.
WV-Q185
Wire hook
section
Cable access
hole (front)
Advertisement
