Related Manuals for Rini ComfortMove
Summary of Contents for Rini ComfortMove
- Page 1 User Manual Special- and Saddle chairs ComfortMove, RiFlex, Dynamic, RiRest, Amazone, Jumper, Classic, SwingFit and more… 2011-0153 v1...
-
Page 2: Table Of Contents
Rini Special- and Saddle chairs Table of content Special and Saddle chairs ..............3 Important - Before use ..............3 Unpacking and installation ............. 3 Intended areas of use ..............3 Basic adjustment of the chairs ............4 Wheels and Trumpet gliders ............4 Tips for comfortable position ............ -
Page 3: Special And Saddle Chairs
Before the product is unpacked make sure that the packaging has not been damaged during transport. If so, document these with a picture and report this to the transport company and your local Rini representative. The chair is normally delivered in parts to save shipping space and is assembled by the following steps. -
Page 4: Basic Adjustment Of The Chairs
3. Basic adjustment of the chairs The picture shows as an example a foot controlled RiRest chair with backrest but all Rini chairs have similar adjustment possibilities. 1. Adjustment of height of backrest 2. Adjustment of seat and backrest angle 3. -
Page 5: Tips For Comfortable Position
Rini Special- and Saddle chairs 4. Tips for comfortable position To achieve the best level of comfort please try the following steps. a) Whilst seated in the chair, adjust the height of the chair to achieve a 90 angle of the legs. The feet shall have the whole sole against the ground during the adjustment. -
Page 6: Tilt Angle And Width Adjustment
Rini Special- and Saddle chairs To achieve optimal seating position: a) Raise the chair so the feet are hanging in the air b) Let your leg and pelvis relax and stretch for some minute, which the gravity takes care of automatically... -
Page 7: Replacing The Gas Spring
7. Replacing the gas spring All Rini chairs can normally be equipped with gas springs with different height span; low, medium and high. To change the gas spring a rubber or plastic hammer is needed. If the gas spring is stuck there are some special tool that can be ordered from Rini, see picture below. -
Page 8: Disinfection, Cleaning & Repairs
Rini Special- and Saddle chairs If the chair is hand controlled hit against the gas spring from underneath the base, this makes the gas spring loosen from the base. Hit with the hammer here If the If the chair is foot controlled there are three screws that hold the height adjustment mechanism that needs to be removed from the gas spring. -
Page 9: Safety
Water and soap Use damp cloth Repairs The product should only be repaired by Rini or a Rini authorised service centre. Product to be repaired under warranty must be sent to Rini factory or an authorised Rini service centre. Unauthorized repairs and modifications may result in loss of function and void warranty. - Page 10 Operator Chair Carl Spring and Carl Swing Rini Ergoteknik AB Fågelsångsvägen 3B SE-186 42 Vallentuna Sweden Phone +46 8 594 77170 Email info@rini.se www.rini.se...
Need help?
Do you have a question about the ComfortMove and is the answer not in the manual?
Questions and answers