Table of Contents
Advertisement
Connecting the Display
Before setting up the monitor, ensure that the power to the monitor, the
computer system, and other attached devices is turned off.
Using the Computer
1.
Connect the signal cable. When attached, tighten the thumbscrews to secure
the connection.
2.
Connect the plug from the AC adapter into the back of the monitor.
3.
Connect the power cord into a proper power outlet that is easily accessible and
close to the display.
4.
Connect the audio cable to the *LINE OUT jack of the PC sound card.
Bottom
PC
MAC
NOTE
This is a simplified representation of the rear view.
This rear view represents a general model; your display may differ from the view as shown.
*LINE OUT
A terminal used to connect to the speaker including a built-in amplifier (Amp). Make sure that
the connecting terminal of the PC sound card is checked before connecting. If the Audio Out of
PC sound card has only Speaker Out, reduce the PC volume.
If the Audio Out of the PC sound card supports both Speaker Out and Line Out, convert to
Line Out using the card jumper of the program (Refer to the Sound Card Manual).
Mac adapter
For Apple Macintosh use, a separate plug adapter is needed to
change the 15 pin high density (3 row) D-sub VGA connector
on the supplied cable to a 15 pin 2 row connector.
A3
PC
Advertisement
Table of Contents
