Toro 111-6032 Installation Instructions

Belt Guard Kit
DH 200 Series Lawn Tractor
Model No. 111-6032
Do not supply these instructions to the customer.
These instructions are for a dealer to install additional belt guards mandated by the French government.
Safety
Important: Refer to the Operator's Manual if
you are unfamiliar with operating this machine
before proceeding. The manual contains important
information about safely operating the machine.
If you do not know this information, you could
seriously injure yourself or others.
Important: You will need to drill holes in the
machine to install this kit. Always wear eye
protection when you drill.
Safety and Instructional
Decals
Safety decals and instructions are easily
visible to the operator and are located
near any area of potential danger.
Replace any decal that is damaged or
lost.
120-1119
1. Fire hazard—read the Operator's Manual.
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Installation
1
Preparing for Installation
No Parts Required
Procedure
1. Park the machine on a level, smooth surface with
sufficient space to access both sides of the mowing
deck.
2. Lower the mowing deck to the shortest cutting
height.
3. Stop the engine, wait for all moving parts to stop, set
the parking brake, remove the ignition key from the
ignition switch, and disconnect the spark-plug wire.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch and
disconnect the wire from the spark plug before
you install the kit. Set the wire aside so that it
does not accidentally contact the spark plug.
4. Raise the rear of the machine off the ground, support
both ends of the rear axle with jack stands, and
remove both rear wheels.
Register at www.Toro.com.
Form No. 3373-761 Rev A
Installation Instructions
Original Instructions (EN)
Printed in the Czech Republic
All Rights Reserved