Toro 98-9880 Installation Instructions
Toro 98-9880 Installation Instructions

Toro 98-9880 Installation Instructions

Tower repair kit for lawn tractors

Advertisement

Loose Parts

Note:
Use the chart below to identify parts used for assembly.
DESCRIPTION
Pivot rod
Hex Spacer nut, 3/8–16 x 1" (26 mm)
Screw, 3/8–16 x 1/2" (13 mm) hex socket head
Threadlocker adhesive #242
Installation Instructions

Installation

1.
Drain the fuel tank; refer to operator's manual.
POTENTIAL HAZARD
In certain conditions gasoline is extremely
flammable and highly explosive.
WHAT CAN HAPPEN
A fire or explosion from gasoline can burn
you, others, and cause property damage.
HOW TO AVOID THE HAZARD
Drain gasoline from the fuel tank when the
engine is cold. Do this outdoors in an open
area. Wipe up any gasoline that spills.
Never drain gasoline near an open flame or
where gasoline fumes may be ignited by a
spark.
Never smoke a cigarette, cigar or pipe.
TOWER REPAIR KIT
for LAWN TRACTORS
PART No. 98–9880
QTY.
1
2
2
1
1
Read before installing
2.
Remove the left side screw securing the fuel tank
rod and tilt rod up. Set the fuel tank on engine to
gain access to the back side of the dash (Fig. 1).
1. Fuel tank rod
2. Screw
FORM NO. 3321–698
INSTALLATION
INSTRUCTIONS
USE
3
1
Figure 1
3. Tower
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 98-9880 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Toro 98-9880

  • Page 1 FORM NO. 3321–698 TOWER REPAIR KIT for LAWN TRACTORS INSTALLATION PART No. 98–9880 INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Pivot rod Hex Spacer nut, 3/8–16 x 1” (26 mm) Screw, 3/8–16 x 1/2” (13 mm) hex socket head Threadlocker adhesive #242 Installation Instructions Read before installing...
  • Page 2 Loosen flange nuts on deck lever pivot rod. Tap Install the new pivot rod through the deck pivot loose from mounting position (Fig. 2). engagement lever. Install the two washers and hairpins, previously removed, on either side of Remove pivot rod, pivot rod clamps, flange the deck engagement lever.

Table of Contents