Dmx Control Channels - ETC ColorSource Spot jr Installation Manual

ETC Installation Guide
ColorSource Spot jr
DMX Control Channels
5ch
DMX
Channel (5 channel)
1 Intensity
2 Red
3 Green
4 Blue
5 Strobe**
6
*Original ColorSource Spot jr fixture uses blue in channel 4; Deep Blue fixture uses indigo in
channel 4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increase the strobe rate
from 1 per second up to 33 per second.
Data Loss Behavior
When DMX data is lost, the fixture does one of the following actions:
If you selected a preset or sequence, that preset or sequence
•
automatically plays.
If no preset or sequence is active in the background, the fixture goes
•
dark and the DMX start address flashes on the user interface.
Play Presets and Sequences
The fixture has twelve factory-configured presets and five factory-configured
sequences. When you play a preset or sequence on a fixture, the same preset
number or sequence number plays on any connected fixtures that are not
receiving DMX. You can re-record presets and sequences through an RDM
device or manually on the fixture. See
1. Press the Mode button to activate the Presets/Sequences menu. The
last active preset or sequence plays automatically. (If DMX data is
present, the current preset or sequence plays in the background and
DMX data continues to take priority.)
2. Press the Up button or Down button as needed to scroll through the
available presets and sequences.
3. To stop the selected preset or sequence, press the Mode button a
second time. The display will revert to show the DMX start address.
ColorSource Spot jr
dir 1ch
(Direct) (1 Channel)
Intensity
Red
Green
Blue/Indigo*
Lime
Strobe**
Re-record Presets on the facing page
Page 8 of 12
rgb
(RGB)
Intensity Red
Green
Blue
.
ETC