Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot jr
Installation
Mounting
The ColorSource Spot jr ships with a standard yoke for mounting with a
clamp. You can adjust the position of the yoke when necessary for low-
clearance mounting. Mount the ColorSourceSpot jr in an orientation where
the knobs are on the bottom. (This ensures that the accessory slot is oriented
correctly, and ensures ease of movement for the Zoom knob and Focus knob.)
Standard yoke position
Safety Cable
A safety cable (or other approved
safety device) must be attached to the
fixture. The attachment loop is on the
rear of the fixture. Take care to leave
as little slack as possible in the safety
cable to avoid catching the yoke of
the fixture.
Connectors
Power: Two powerCON
•
Data (DMX512/RDM): Two five-pin XLR connectors for data in and
•
thru
Note:
terminate the last fixture in line with a 120 Ohm resistor. To purchase
a terminator, please contact ETC customer service and request part
number SGE1507 (XLR terminator).
ColorSource Spot jr
The ColorSource Spot jr is not self terminating. You must
®
connectors for power in and thru
Page 4 of 12
Low-clearance yoke position
Safety cable
attachment loop
ETC
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorSource Spot jr and is the answer not in the manual?