Table of Contents
Advertisement
Safety instructions for the installer
WARNING
Do not open the equipment.
Only qualified personnel should work
inside the equipment.
Turn off the power at the main switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Confirm that there is no water leakage at
the transducer and temperature
sensor.
WARNING
Water leakage can sink the vessel. Also,
confirm that neither the transducer or
sensor is loosened by vibration. The
installer is solely responsible for the
installation.
Confirm that the power supply voltage
is within the rating of this equipment.
Incorrect voltage will damage the equip-
ment and may cause fire.
CAUTION
CAUTION
The transducer cable must be handled
carefully, following the guidelines
below.
Keep fuels and oils away from the
●
cable.
Locate the cable away from chemicals.
●
Locate the cable away from locations
●
where it might be damaged.
Do not turn on the power with the
transducer exposed to air.
Damage to the transducer may result.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Standard
compass
0.30 m
iii
SAFETY INSTRUCTIONS
Steering
compass
0.30 m
Advertisement
Table of Contents
