Table of Contents
Advertisement
In between pre-recorded message plays, the DV-2000 MTS/LR will output the background
music, BGM, audio to the audio output. The DV-2000 MTS/LR will gently fade the BGM
audio up after a pre-recorded message is played, and it will gently fade the BGM audio
down just prior to a pre-recorded message play.
3.4 Pushbutton descriptions
Eject / Rec Stop pushbutton – Red, momentary
Allows the user to stop the recording process, in several ways, and/or eject the tape.
-When the system is not recording, the button functions as an Eject button.
-When the DV-2000 MTS/LR is recording audio, (whenever the Record LED is on) pressing
this button momentarily will stop the recording and save the Audio which was just
recorded. The system will rewind the tape, but not eject it.
-If this button is pressed and held for two seconds while the DV-2000 MTS/LR is recording,
the message just recorded will be deleted, and the tape will be ejected without being
rewound.
-If the button is pressed momentarily while the DV-2000 MTS/LR is recording audio, and
then pressed momentarily again, the system will stop the recording process, save the
Audio just recorded, and eject the cassette tape without rewinding it.
Append / Replace pushbutton – Black, momentary
Pressing this button toggles the Replace/Append mode. The status of the Append and
Replace mode is signified by the Replace/Append LED. When this LED is on, the system is
in Replace/Append mode. This setting is not saved when power is removed, and reapplied
to the unit.
Operation of the unit in Replace/Append mode is described in the Message Download
section(3.1).
Speaker pushbutton – Black, locking
A monitor speaker, on the front side of the unit, allows the local user to hear the Audio being
output by the DV-2000 MTS/LR. Pressing this button will activate the monitor speaker.
Releasing the button will deactivate the monitor speaker.
The volume of the monitor speaker is determined by the volume setting of the Audio output.
If the phone system requires a particularly low level from the DV-2000 MTS/LR, the volume
of the monitor speaker will also be low.
Note: Do not adjust the Audio output level adjustment in order to hear the monitor
speaker level better. Doing this will adjust the level of the Audio output which may
not be acceptable.
Local Record pushbutton – Green, momentary
Pressing this initiates local recording.
3.5 LED (Light Emitting Diodes) descriptions
Eject LED, Yellow
This LED will light whenever the tape is ejected, i.e. no tape in the system. When a tape is
inserted, and loaded, i.e. tape is completely inside the machine, this LED will go out.
Record LED, Red
This LED will light when the DV-2000 MTS/LR starts recording an Audio program, and will
go out when the recording process stops. This LED also blinks while the system is in local
record setup mode.
The Record LED will blink one time when the DV-2000 MTS/LR is powered on, indicating
that the memory operational.
M-O-H LED, Green
This LED will light whenever the DV-2000 MTS/LR is in automatic playback mode and
playing messages, or outputting the BGM audio.
10
Advertisement
Table of Contents
