Table of Contents
Advertisement
2. Installation:
This section provides complete instructions for mounting the DV-2000 MTS/LR. Before you install
the DV-2000 MTS/LR system, make sure you have:
-A message or music on hold input on your phone system or line level input to your public
address system.
-A non-switchable 110VAC electrical outlet near the location where the unit is to be installed.
2.1 Wall or Table Installation:
1. Locate a proper space on the telephone equipment board or wall. You can mount the
DV-2000 MTS/LR unit in one of three positions: flat, side, or horizontal.
2. Position the unit on the board; mark the mounting hole locations.
3. Using the mounting screws provided, secure the DV-2000 MTS/LR system to the board or
wall.
4. If table top mounting the DV-2000 MTS/LR, stick the enclosed rubber feet on the bottom of
the unit.
DIGITAL AUTOLOAD STORECASTER
&
MUSIC THRU SYSTEM
DV-2000 MTS/LR SERIES
EJECT
REC STOP
MESSAGE SELECTION
MUSIC INTERVAL
1
2
3
4
5
6
7
8
9
10
APPEND
REPLACE
ON
TENS
ONES
OFF
EJECT
11
12
13
14
15
16
17
18
19
20
ON
REC
OFF
PLAY MODE
AUDIO
LOCAL
MUSIC ONLY
BGM FADE
RECORD
MODE
MUSIC & MESSAGE
SPEAKER
APPEND
MESSAGE ONLY
DOWN
UP
REPLACE
12VDC
_
LEVEL
APHEX
LEVEL
HANDSET
+
BGM IN
LINE OUT
SPKR OUT
INPUT
2.2 Connecting the power pack
1. Plug the power pack into a 120VAC power outlet which is not connected to a switch.
2. Plug the power plug into the DV-2000 MTS/LR system's power jack marked 12VDC.
3. There is no power switch on the DV-2000 MTS/LR system, so as soon as power is
connected, the system will be active.
2.3 Connection to Telephone equipment
1. Connect one side of the supplied RCA cable to the telephone equipment's Message-On-
Hold input. Connect the other side of this cable to the DV-2000 MTS/LR's LINE OUT. There
are two audio outputs on the DV-2000 MTS/LR, LINE OUT (low level, +4dB into 600 ohms),
and SPKR OUT (high level, 1W into 8 ohms). Use the LINE OUT first adjusting the audio
output volume potentiometer to obtain the correct audio level. If this does not provide
enough audio level, then switch to the SPKR OUT.
2.4 Connection to the PA equipment
1. Connect one side of the supplied RCA – RCA cable to the PA amplifier's line level input.
Connect the other side of this cable to the DV-2000 MTS/LR's LINE OUT. There are two
Audio outputs on the DV-2000 MTS/LR, LINE OUT(Low, +4dB into 600 ohms), and SPKR
OUT(High, 1W into 8 ohms). Use the LINE OUT first adjusting the audio output volume
potentiometer to obtain the correct audio level. If this does not provide enough audio level,
then switch to the SPKR OUT.
A
R
MIN
SEC
Figure 1 - Mounting
B
Mounting Options:
A. Back of unit
against wall - flat ( 10" x 8" )
B. Left side of unit
against wall - side ( 2.2" x 8" )
C. Left side of unit
against wall horizontally ( 8" x 2.2" )
C
5
Advertisement
Table of Contents
