Table of Contents
Advertisement
If there are more messages on the cassette tape then there are messages on the
machine set up to be overwritten, the DV-2000 MTS/LR will append the extra messages
until there are twenty messages recorded on the system, or until the last message on the
cassette tape is reached.
Example: The DV-2000 MTS/LR system has ten messages currently recorded on the
system. To replace message 3 and 7 with new messages and add three more messages
to the system follow the steps below:
1. Activate the Replace/Append mode.
2. Enable message selection switches 3 and 7.
3. Disable all other message selection switches.
4. Insert the cassette tape which has the five new messages on it.
5. The system will record the first message on the tape into message location #3.
6. The system will record the second message on the tape into message location #7.
7. The system will then record the last three messages of the cassette tape into locations
#11, 12, and 13 on the DV-2000 MTS/LR, respectively.
It is not necessary to enable a message location to Append messages to memory. If the
user wants to simply append messages to the system, activate the Replace/Append
mode and disable all of the message selection switches. Insert the cassette tape with the
new messages into the DV-2000 MTS/LR and it will record the messages on the tape to
any empty message locations on the machine.
The Audio being recorded will be output though the 8 ohm and line outputs during the
recording process. This audio may also be monitored locally by depressing the "Speaker"
button.
3.2 Message Downloading - Local Record Handset:
You may also create messages for the DV-2000 MTS/LR by recording them directly to the unit
using the optional LR-HSET handset. This feature allows you to make a custom recording to
any of the 20 message locations on the unit. These messages may be updated at any time for
maximum flexibility.
1. Plug the LR-HSET(sold separately) into the Local Record Input.
2. Press the Local Record pushbutton to initiate the record sequence, Record LED(RED) will
blink.
3. Toggle the desired message location switch two(2) times to begin recording.*
4. The Record LED should now be illuminated, record your message into the handset.
5. Press the Record(RED) button to stop recording.
6. A preview of the message will automatically be played after the recording has been stopped.
*NOTE: Local recordings may be made to message locations that are either enabled or
disabled. If disabled, toggle the switch up then down to begin recording. If the message
location is enabled, toggle the switch down then up to begin recording. Always leave the switch
up, or enabled, if you want it to playback.
3.3 Automatic message playback
After messages have been recorded into memory, the DV-2000 MTS/LR will automatically
begin playing them through the audio outputs. There is no control, or user input, required to
initiate the playback. The green, Audio LED will light whenever the system is playing
messages.
All enabled messages will be played back sequentially. If an enable switch is active, but has
no associated message recorded into that position, the position will be skipped.
The messages in memory are automatically played back sequentially with a user programmed
delay time inserted between them(see section 3.7 for delay configuration information).
7
Advertisement
Table of Contents
