Circuit Breaker And Fuses; Seat Panel Latch; Rear Body; Hourmeter - Walker B27i Operator's Manual

Operating Instructions
sub-standard performance and MAY cause engine
damage if not corrected as soon as possible.

Circuit Breaker and Fuses

Two (2) 5 amp fuses are located underneath the
seat panel adjacent to ignition switch, and they
protect the safety circuits and relays. An auto-
reset 30 amp master circuit breaker is located in
the rear left of the chassis and protects the chang-
ing system. In addition, there are two (2) 10 amp
fuses, and one (1) 30 amp fuse included on the
engine to protect the ECU, EFI system, and charg-
ing system. Refer to the Kohler engine manual
included with the Owner's Packet of materials for
information regarding these fuses.

Seat Panel Latch

The seat panel hinges forward for maintenance
access and is latched down in the OPERATING
position. To raise the seat, pull outward on latch
and lift the seat.
Seat Panel
Latch
Seat Panel Latch

Rear Body

The rear body or optional dump bed is hinged and
tilts back for maintenance access.
Lifting Rear Body
(Optional Dump Bed Shown)
30

Hourmeter

The hourmeter, which is located on the right front
of the body, displays operating time accumulated
when the PTO (blade drive) is engaged.
The hourmeter provides maintenance reminders
after certain hours of operation. The hourmeter
screen will start flashing the reminder one hour
prior to the recommended interval and will continue
until one hour after the recommended interval (two
hours). The hourmeter does not have a manual
reset function.
Procedure Interval*
Oil Change
4-6 Hours
(Break-In)**
Lubricate
and Check 24-26 Hours
Levels
Oil Change 49-51 Hours***
* These intervals reflect the actual time that the
reminder will flash (one hour prior to and one
hour after the recommended interval).
** This reminder is only used one time.
*** In normal operating conditions, oil changes in
100-hour intervals are acceptable. Walker and
the engine manufacturers recommend engine
oil changes every 50 hours in extremely dirty
or dusty conditions or for units with less than
100 hours annual use.
NOTE: The blinking hour glass on the display
means that the meter is operating properly.
Hourmeter
B27i
Reminder
C
H OIL
G
LUBE
C
H OIL
G