Lightware DVI-OPT-TX110 Quick Start Manual page 2

1 DVI connector Connect to DVI source for transmitter use.
Connect to display device to learn EDID.
2 Power LED Lights green if the power supply is sufficient.
(DVI or external adaptor supply)
3 EDID LED Three color LED displays EDID status.
See legend for indications.
4 LEARN button Press for 2 seconds to activate learn mode.
Press for 10 seconds to restore factory EDID.
Power connector Barrel plug receptacle for external power adaptor.
5
6 Fiber connector SC type receptacle for multimode fiber output.
Thumb-screw Recessed, slotted thumbscrew for easy mounting by
7
hand or by screwdriver.
www.lightware.eu
For technical support contact support@lightware.eu
1 DVI connector
2 Power LED
3 EDID LED
4 Learn button
Power connector
5
6 Fiber connector
Thumb-screw
7
DVI connector Connect to DVI display.
1
Power LED Lights green if the unit is powered on.
2
Hotplug LED Indicates that the display device is connected correctly.
3
4 Laser LED Green light indicates that the laser is properly detected
on the optical input.
5 Power connector Barrel plug receptacle for external power adaptor.
Fiber connector SC type receptacle for multimode fiber input.
6
Thumb-screw Recessed, slotted thumbscrew for easy mounting by
7
hand or by screwdriver.
DVI-OPT-TX110 and DVI-OPT-RX110
Quick Start Guide
1 DVI connector
2 Power LED
3 Hotplug LED
3 Laser LED
Power connector
5
6 Fiber connector
7 Thumb-screw
DVI-OPT-TX110 firmware version: 1.1.6
Document revision: 1.0