Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Genexis OCG-GNP2110
Summary of Contents for Genexis OCG-GNP2110
- Page 1 OCG-GN- P2110 Installation Guide...
- Page 2 LED & port overview Power Green – system ok – power off Glas Green – WAN link ok Green (blinking) – WAN port connected, traffic ongoing – no WAN link Ethernet Green – link up with 1G speed Yellow – link up with 10/100M speed Green/Yellow (blinking) –...
- Page 3 Installation guide Getting started Setting up the OCG Check if the following items are in the giftbox 1. If present, remove the seal sticker that 5. Slide the blue connector down to • OCG-GN-P2110 covers the screw and remove the seal tag. disconnect it from the old product.
- Page 4 Remove dustcap (optional) Installation of OCG-GN-P2110 If there is a new activation the fiber 3. Move the blue connector down, back in 1. Remove the dustcap of the blue coupler connector is protected by a dustcap the original position. on the OCG. 1.
- Page 5 Optional Finish 4. Place the white cover by pushing it away • Place the screw at the bottom to lock the 1. Connect the OCG LAN port to the from you. two plastic parts. residential gateway. 5. Slide the white cover up. You will hear •...
- Page 6 Safety and Care Operating Conditions Care • Do not operate the device in temperatures below 0° C or above 40° C. • Always unplug your OCG from the power supply before cleaning! • If needed, the OCG can be cleaned by wiping it over using a soft, dry cloth. Avoid any abrasive Safe Operation material that might scratch or damage the surface.
- Page 7 Revision 1.0 - January 2020 Copyright © 2020 Genexis B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the OCG-GNP2110 and is the answer not in the manual?
Questions and answers