Installing A Power Supply And Cooling Module - Dell EqualLogic PS6010 Hardware Maintenance

PS6010 Hardware Maintenance

Installing a Power Supply and Cooling Module

Caution: The module is heavy; support it with two hands.
To install a power supply and cooling module in an array:
1. Attach an electrostatic wrist strap, as described in Using an Electrostatic Wrist
Strap on page 1-5.
2. Squeeze the latches inward (see callout 1 in Figure 4-2) to release the handle
and then rotate the handle upward see (callout 2 in Figure 4-2).
3. Hold the handle and slide the module into the slot, until you feel resistance.
See Figure 4-4.
Figure 4-4: Installing a Power Supply and Cooling Module
4. Rotate the handle downward until it engages with the latches and the module
is completely inserted. Refer back to Figure 4-2.
5. Attach the power cable to the module. If your PS Series array was shipped
with a power cable, use this cable to meet safety requirements.
4–4
Maintaining Power Supply Modules