Power Supply - Dell PowerVault 715N Service Manual

9. Install the riser card.
10. Install the expansion
11. Install the fan assembly.
12. Replace the system
13. Replace the bezel.
14. Reconnect any external peripheral cables that you disconnected from their connectors at the back of the system.
15. Connect the power to the system and turn on the system.
System Board Features
Figure 9 defines the system board features. The system board labels are in parentheses. Refer to this figure when
replacing your system board or components that attach to the system board.
Figure 9. System Board Features

Power Supply

Your system has a single power supply, which is secured by a locking tab and four screws (see
CAUTION: Read the safety instructions in your System Information document.
Figure 10. Power Supply Removal
card.
cover.
1 Fan power connector (CPUFAN1)
2 DIP switch (SW3)
3 Microprocessor and heat sink (CPU)
4 Power supply connectors (CN1 and CN2)
5 Serial port connector (COM1)
6 Memory modules (DIMM1 and DIMM2)
7 PCI riser card slot (PCI1)
8 LAN connectors (LAN1 and LAN2)
9 Battery connector (BT1)
10 Clear CMOS jumper (JP1)
11 System version jumper (JP5)
1 Locking tab
2 Power supply
3 Screws (4)
Figure 10).