Whirlpool WHAB-6012 Installation Instructions And Use And Care Manual page 15

PERFORMANCE DATA SHEETS
Water Filtration System,
Replacement Filter A (
Replacement Filter B (
Replacement Filter C (
CONDITIONS FOR SYSTEM USE
Source Water Supply Profile
Community/Private Chlorinated/NonChlorinated
System Pressure 208 – 690 kPa (30-100 psig)
Temperature 4° - 38° C (40° - 100° F)
NOTE: Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
Filtration Assembly
Major Components
Sediment Filter
Lead & Cyst Filter
VOC Filter
Water Quality Monitor/Performance Indicator:
A monitor is used to track the number of gallons that flows through the filtration system. The monitor is
preset at the factory to indicate when it is time to change the filters. When the water is flowing, either the
green "good" light will illuminate indicating less than the rated gallon count or the yellow "fair" light will
illuminate indicating the rated gallon count has been exceeded. The red light will illuminate during water
flow if a year has passed since previous filter change or the gallon count has been exceeded. The monitor
should be reset each time the filters are replaced. Two AA batteries, located inside the monitor box at the
filter outlet, supply power to the monitor. Reset the monitor by removing the batteries, then putting them
back in. Replace batteries yearly or at filter change to ensure uninterrupted monitoring. Two AA batteries
are included with each replacement filter A.
models WHAF-0335AB, WHAF-0435AC
model WHAB-6009)
model WHAB-6010)
model WHAB-6011)
REFERENCE DATA
Application Guidelines
Use this drinking water system on potable
water supply only.
CAUTION: Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system.
Component
Part Number
WHAB-6009 (A)
WHAB-6010 (B)
WHAB-6011 (C)
Routine Maintenance
Replace filters as required
or every 6 to 12 months
depending on feed water quality.
15