Performance Data Sheets - Whirlpool WHAB-6012 Installation Instructions And Use And Care Manual

Water Filtration System,
The system conforms to ANSI/NSF 42 and 53 for the specific performance claims as verified and substantiated
by test data. The system has been tested according to ANSI/NSF 42 and 53 for reduction of substances listed
below. The concentration of the indicated substances in water entering the system was reduced to a
concentration less than or equal to the permissible limit for water leaving the system, as specified in
ANSI/NSF 42 and 53.
ANSI/NSF STANDARD 42
Substance
Chlorine, taste and odor
Particulate, Class I particles
0.5 mm to <1 mm
ANSI/NSF STANDARD 53
Substance
Turbidity
Lead pH 6.5
Lead pH 8.5
VOC*
Mercury*
MTBE*
*VOC, MTBE and Mercury claims only apply when filter WHAB-6011 is use in conjunction with filter WHAB-6009 or WHAB-6010.
Substance
Cysts
Asbestos
NOTE: Certification for Cysts reduction includes Cryptosporidium and Giardia lamblia.
OUTPUT PERFORMANCE
NOTES:
Testing was performed under standard laboratory conditions. System performance may vary according
to local water conditions.
Contaminants listed in this Data Sheet are not necessarily in your water.
We recommend your water be tested to determine treatment requirements.
® NSF is a registered trademark of NSF International.
14

PERFORMANCE DATA SHEETS

Replacement Filter A (
Replacement Filter B (
Replacement Filter C (
DATA SHEET REDUCTION CLAIMS
Influent challenge
concentration
2.0 mg/L ± 10%
At least 10,000 particles/ml
Influent challenge
concentration mg/L
11 ± 1 NTU
0.15 ± 10%
0.15 ± 10%
Refer to pages 17 and 18 for individual contaminant performance data.
0.006 ± 10%
0.015 ± 20%
Influent challenge
concentration
Min. 50,000/L
10 7 to 10 8 fibers/L: fibers
greater than 10 µm in length
SERVICE FLOW RATE AND CAPACITY
2.3 Liters/minute (0.6 gallon/minute)
Actual rate varies according to water pressure.
Capacity of 4542 Liters (1200 gallons)
models WHAF-0335AB, WHAF-0435AC
model WHAB-6009)
model WHAB-6010)
model WHAB-6011)
CARBON FILTER TESTED: Lead/Cyst
Avg.
% Rej.
97.5
97.0
CARBON FILTER TESTED: Lead/Cyst
Avg. Max. permissible product water
% Rej. concentration mg/L
96.50 0.5 NTU
99.30 0.010
99.30 0.010
96.50 0.002
94.20 0.005
Avg. Reduction
% Rej. requirement
99.99 99.95%
99.00 99.00%
RATED AT CONTAMINANT REDUCTION TEST PARAMETERS
Reduction
requirement
50%
85%