Add Static Routes - TRENDnet TEW-830MDR User Manual

TRENDnet User's Guide
3. Under IPv6 Connection Type in Protocol drop-down list, select the type of Internet
connection provided by your Internet Service Provider (ISP).
4. Complete the fields required by your ISP.
5. To save changes to this section, click Apply at the bottom of the page when finished.
Note: Please contact your ISP for IPv6 service availability.
Select the IPv6 connection type provided by your ISP.
Static IPv6
•
• PPPoE
• Autoconfiguration
• 6rd
Link-Local Only
•
© Copyright 2020 TRENDnet. All Rights Reserved.

Add static routes

Interfaces > Routes
You may want set up your router to route computers or devices on your network to
other local networks through other routers. Generally, different networks can be
determined by the IP addressing assigned to those networks. Generally speaking and for
the case of an example, your network may have 192.168.10.x IP addressing and another
network may have 192.168.20.x IP addressing and because the IP addressing of these
two networks are different, they are separate networks. In order to communicate
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see
on page 23).
2. Click on Interfaces and click on Routes.
3. In the Static IPv4 Routes section, click the
• Destination LAN IP: Enter the IP network address of the destination network for
the route. (e.g. 192.168.20.0)
• Subnet Mask: Enter the subnet mask of the destination network for the
route.(e.g. 255.255.255.0)
• Default Gateway: Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)
• Metric: Enter the metric or priority of the route. The metric range is 1-256, the
lowest number 1 being the highest priority. (e.g. 1 )
• Interface – Select the interface to assign the route, LAN or WAN.
TEW-830MDR / TEW-830MDR2K
"Access your router management
icon to add a new static route.
page"
36