Add Static Routes To Your Router; Enable Rip On Your Router - TRENDnet AC750 User Manual

TRENDnet User's Guide
4. Next to MAC Clone select Enable on the pull down menu. Manually enter you MAC
address or click Copy Your PC's MAC address to copy your computer's MAC address.
Note: You can check the DHCP Client List for the MAC addresses of the devices on
your network, see page 36 or refer to your computer or device documentation to
find the MAC address.

Add static routes to your router

Advanced > Setup > Routing
You may want set up your router to route computers or devices on your network to
other local networks through other routers. Generally, different networks can be
determined by the IP addressing assigned to those networks. Generally speaking and for
the case of an example, your network may have 192.168.10.x IP addressing and another
network may have 192.168.20.x IP addressing and because the IP addressing of these
two networks are different, they are separate networks. In order to communicate
between the two separate networks, static routing needs to be configured. Below is an
example diagram where routing is needed for devices and computers on your network
to access the other network.
Note: Configuring this feature assumes that you have some general networking
knowledge.
1. Log into your router management page (see
on page 15).
2. Click on the Advanced tab.
3. Click on the Setup section and click on Routing.
© Copyright 2013 TRENDnet. All Rights Reserved.
"Access your router management page"
4. Review the LAN/WAN Static Routes section. Click Apply to save settings.
• Destination IP Address: Enter the IP network address of the destination network
for the route. (e.g. 192.168.20.0)
• Destination IP Netmask: Enter the subnet mask of the destination network for the
route. (e.g. 255.255.255.0)
• Gateway: Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)
• Metric: Enter the metric or priority of the route. The metric range is 1-15, the
lowest number 1 being the highest priority. (e.g. 1 )
• Interface: Select WAN on the pull down menu.

Enable RIP on your router

Advanced > Setup > Routing
1. Log into your router management page (see
on page 15).
2. Click on the Advanced tab.
TEW-810DR
"Access your router management page"
27