Racal Instruments 7064 Instruction Manual page 160

Misscelaneous commands
clear done (void); *
The user should send this command to his routine in response to the WS clear
command (VXlbus specifications).
setparser (ulong address);
Sets the user parser.
NOTE: The commands marked with an asterix (*) are only available for
firmware development. A l l other commands are available either through the
message based interface or for firmware development.
Production Rules Describing 7064 Command Syntax.
<cmdlist> => <cmd>+ / * A 7064 command list is 1 or more 7064 commands */
/* A 7064 command "is a" bit command "or a" byte command, ... */
<cmd> => <bit_cmd> ';'
I <byte_cmd> ';'
I <word_cmd> ';'
I <trig_cmd> ';'
I <block_cmd> ';'
I <base_cmd> ';'
I <usr_cmd> ';'
I <peek_cmd> ';'
<poke_cmd> ';'
I <nv_cmd> ';'
I <vect_cmd> ';'
I <setparser_cmd> ';'
I <parsemode_cmd> ';'
A-12