Dell EqualLogic PS Series Hardware Owner's Manual page 35

PS6610 Hardware Owner's Manual
If the screw falls inside the control module, you might have to return the control module to Dell
Note:
for servicing.
4. Using the screw tab as a handle, swing the battery cover up and to the left and lay it upside down
on the control module
battery is attached to the cover.
5. The connector that connects to the battery unit is held in place by a retaining clip, which must be
depressed to remove the connector, as shown in
while simultaneously depressing the retaining clip, and wiggle the connector gently side to side
while pulling outward to remove it. Set the old battery unit aside.
(Figure 20). The battery cover will be heavier than expected because the
Figure 20: Removing the Battery Cover
Figure 21: Disconnecting the Battery
3 Control Module Maintenance
Figure 21. Grasp the outside of the connector,
29