Dashboard Controls - Te Pari Racewell HD3 Operator's Manual

Racewell HD

Dashboard controls

Your Racewell handler has a number of different operating modes. These are explained below.
(Starting from the Left button on the dashboard)
Power
When power is connected to the Racewell Handler it can then be powered on via the
dashboard power button. When the Racewell Handler is ON the button will glow green. It is
strongly recommended to turn the racewell Handler off when you have finished working.
Draft gates
The draft gate switch will move the postion of the Drafting gates to the left
or right. When Auto drafting the switch must be set to AUTO. The draft gate
direction can be changed at any time during weighing and drafting should you
wish to change the direction manually.
Release button
When set to AUTO the sheep will be automaticlly released from the Clamp and
weigh area when it has been weighed. If set to MANUAL then the operator will
have to press the release button for the sheep to be released.
Tilt
The tilt switch will move the Clamp and Weigh area up or down for access to the
sheep.
6
S H E E P H A N D L I N G S YS TE M S
Te Pari Racewell HD3, HD4 & HD6 Operators Manual